Are you new to LinuxQuestions. OK, this is bizarre. Having a problem logging in? Any chance of someone helping us new linux users by writing a step by step kids book about installing this PCMCIA card? Please visit this page to clear all LQ-related cookies.

Uploader: Aragami
Date Added: 10 September 2012
File Size: 58.26 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 69297
Price: Free* [*Free Regsitration Required]

Email me about changes to this bug lnux. Seems to fail under a heavy load. If you’d like to contribute content, let us know.

I did not have the problem reported by Andrei Magureanu. It’s not that Wireshark stops or that i get any errors, there just stops comming new packets, which i know is wrong.

Loaded prism54 driver, version 1. So I moved onto the network setup using iwconfig, assigning essid, keys… Ran dhcpcd. Does anyone have an idea as to what happened to prism Please provide dmesg output.

I am not sure if this is caused by the absence of the ARM file. Here is the part that got cutoff:. Thank you very much.

[ubuntu] Netgear WGT and WPA2

If i reset the card in promiscuous mode, then it works fine for a short period of time then the same thing happens again. You are not directly subscribed to this bug’s notifications.


I used the drivers at Linuxant. You are currently viewing LQ as a guest.

WG511T – 108 Mbps Wireless PC Card

You can use this driver with every distro since you build your own kernel. Leave a Reply Cancel reply Your email address will not be published. Today, without any updates I used the network connection system tray icon, and notice that it shows the AP’s and so I went through the configuration via this applet linhx thinking it would make any difference.

Okay, so here are the error messages that get printed when I do “modprobe prism54”:. The problem now is saving the settings to run automatically. I really want to go on the internet with my OS Lindows. Comment on this change optional. Either I’ve had a complete moment of stupidity or there is something not quite wg511r about the Wireless network management.

You should look on mandrake mailing list, i think. No IRQ known for interrupt pin B of device Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter.


NetGear WG511 on Linux

I did get a copy of the ARM as advised above but using this the card failed to initialise at all. Okay, I have double checked, but after llnux kernel finishes booting, loading all modules, and I login as “root”, I did an “lsmod” to list all modules that are loaded and here is the full list: This does not appear to be a kernel bug.

I usually use a Cisco Aironet but the new one is a 54g so. I got a Linksys Wireless Card.

Ben Collins ben-collins wrote on Rebooted the system, but I get the following error: My system recognizes its wired ethernet port as eth0 and the Netgear card as eth1.